Adhesive Remover | Window film adhesive remover

Avery Dennison® Adhesive Remover | Window film adhesive remover

Advantages

Description

Brief Explanation
If you wish to remove self-adhesive window film from glass, it is inevitable that adhesive residue will remain. This is because the film adheres to the glass via a layer of glue. The best method to remove window film is to start at a corner and carefully peel the film away from the glass. After removing the film, adhesive residue will be left behind. This residue should be sprayed with Avery Dennison® Adhesive Remover.

Contents
The contents of the Avery Dennison® Adhesive Remover amount to 0.5 litres.

Usage
After thoroughly spraying the glass and adhesive residue with the solution, wait 60 to 90 seconds to allow Avery Dennison® Adhesive Remover to take effect. Once it has soaked in, you will see the glue start to dissolve and detach from the glass. You can then use a glass scraper to scrape the residue off the glass. This will make the surface 100% free from adhesive. Afterwards, you can clean the glass using a standard glass cleaner or SCALASOL® TO-PREPARE.

• Important Instructions

• • Use in a well-ventilated area
  • Avoid contact with skin and eyes
  • Preferably wear protective gloves
  • Keep away from open flames and heat sources (flammable)
  • Keep out of reach of children and animals
  • Do not ingest; seek immediate medical attention if swallowed
  • In case of eye contact, rinse thoroughly with water and seek medical advice
  
  Downloads
  Safety Data Sheet